You are viewing our Forum Archives. To view or take place in current topics click here.
RGH writing Nand help?
Posted:

RGH writing Nand help?Posted:

TTGWill
  • New Member
Status: Offline
Joined: Jan 29, 201014Year Member
Posts: 5
Reputation Power: 0
Status: Offline
Joined: Jan 29, 201014Year Member
Posts: 5
Reputation Power: 0
Got up to the part where you create a image of your nand, however, writing the nand on the xbox, no screen or video loads.
Other notes:
Console:Falcon
CoolRunner: Rev B
Program: J-Runner
Booting up with new nand: No red rings, just no video or syncing of xbox controllers
#2. Posted:
FriedModz
  • Junior Member
Status: Offline
Joined: Feb 12, 201212Year Member
Posts: 56
Reputation Power: 2
Status: Offline
Joined: Feb 12, 201212Year Member
Posts: 56
Reputation Power: 2
Ok well I had the same problem! I actually think my coolrunner was faulty, but this is what I was told to test and see if your nand wasn't corrupt. First unsolder all the coolruner wires from the board. Next write the original nand, you read off of the board back to it. Turn it on and see if it boots. If it does then you have a clean nand, but if it doesn't you have some bad blocks somewhere.Now I don't remember if J-Runner has bad block remapper like jtag tool. But if it does run the nand through that and it should fix the bad blocks. Also if you don't have any bad blocks what dashboard was the console on when you did the first reads of the nand? Because if you didn't know the recent updates we had from microsoft for our dashboards was to stop RGH's. It splits the CB into two where you can't make a full ecc image to do the RGH hack. If you did the Rgh past I believe it was the 13146 update then that might be your problem! Let me know what you find and I will help you as best as I can! -FriedModz
Jump to:
You are viewing our Forum Archives. To view or take place in current topics click here.