images would be of great help, have you programmed your glitch chip witht correct files being rgh1 or rgh2.

Recompile your ecc and flash it again, reboot... if nothing then,
original dumps all matched?
did to have any bad blocks in the first 50?
I see your using coolruner rev c, have you removed the blank resistors and bridged the pads correctly in reference to the guide being rgh1 or 2.

yessir i flased the coolrunner with A should i try other files/

alright i tried again but it didnt work, no bad blocks and matching nands (using j runner)

Absoltley try all teh xsvf files, there there some may work and others may not, you will have to find the config that works best.

If you dont have green led shwing debugs every 5 secs you need to post pictures of your soldering to get help.

remove correct and bridge correct pads on Coolrunner device.

Alright here are the best picture i could get

[ Register or Signin to view external links. ]

[ Register or Signin to view external links. ]

[ Register or Signin to view external links. ]

[ Register or Signin to view external links. ]

Try standard Cpu_Rst Wire(blue) remove the 50ohm cable

What about the underside? have you made sure you didnt mix up i2c and other point?

Try desoldering B(stb_clk) And soldering it to the bottom ALT point to see if that changes things.

I cant see but it looks like you havent removed/bridged the blank resistors on 1,2,JP that come on the rev c coolrunners.

All fo this will contribute to how well it gltiches for you, but firs you need to get the debug led blinking so try what i have suggested and we can cover the rest later.

alright thanks man ill try to use the blue wire and check the backside nut if that doesnt fix it ill use the alt point and where is that btw just on the opposite side of the original point?

MirakuhL wrote alright thanks man ill try to use the blue wire and check the backside nut if that doesnt fix it ill use the alt point and where is that btw just on the opposite side of the original point?

[ Register or Signin to view external links. ]

solder it directly there from B pad.

removed resistors and bridged pads on coolrunner.. correct?

alright it still wont work but im on to try the orange wire and yes cap is open jp is closed and 2-3 is closed