grrr. any ideas anyone???

sounds like ur xbox has something wrong with the heatsinks, hardware, not ur flash.

Pistolvania wrote sounds like ur xbox has something wrong with the heatsinks, hardware, not ur flash.

Why then did it happen RIGHT AFTER the flash? Legitimatly, I flashed it. It shut down. I turn it back on after 10 seconds with power cord unplugged.

3 red rings...

anybody know anything??

dloe48 wrote anybody know anything??

If you don't think it's a hardware issue, then try re-flashing a working nand image. If you can boot into xell, you can re-flash easily. To boot into xell hold the eject button and xell should come up on screen. If xell doesn't boot up then you will need to re-flash it with an LPT cable or a nand flasher (like nand-x). I recommend nand-x, very easy to set up, and extremely easy to use

You tried to update to fbbuild 0.1 right?

If so, this is your problem more than likely..

You need to take your Jtag apart and look for r6t3 and remove it..

Infinite_94 wrote

dloe48 wrote anybody know anything??

If you don't think it's a hardware issue, then try re-flashing a working nand image. If you can boot into xell, you can re-flash easily. To boot into xell hold the eject button and xell should come up on screen. If xell doesn't boot up then you will need to re-flash it with an LPT cable or a nand flasher (like nand-x). I recommend nand-x, very easy to set up, and extremely easy to use

nand-x FTW

Reflash it (LPT) And get your error code by hitting sync and eject 4 times 8)

i have read this whole post and not ounce did he answer if it boots into Xell, unless i over looked it. Turn on your jtag using your eject button and let me kow if it boots into Xell, if so ill post inst. on how to fix it.

If not then you have to find another solution.

TTG-GMz-Tagz wrote You will prob need to reflash it via LPT.

u may so or u just have the brigde that needed to be removed...

correct steps!

Pre-

-Get ur Current nand- flashdmp.bin

-make sure the brigde is disconnected


Steps-

1.) Open EBE

2.) If u have an audio clamp then click "fix audio clamp"

3.) onces that is checked, click create image

4.) a window should pop up. Click ur current nand- flashdmp.bin

5.) then a window should pop up, ENTER ur CPU key

6.) put that image with the folder Flash 360 on ur USB

7.) Go to the xex menu then Flash 360 and dump that new nand to ur jtag

8.) unplug ur power cord and wait 10 seconds and there u go.