:L no thats the whole point of the bricking of the jtag

Yes, depending on what you did and how you did it. So if you have you need to give more info so we can help you.

Well kyle i went to upgrade to 13196 or watever the new dash is and i used the jtag tool and im tryin to reflash my orignial nand but i cant boot into xell

it depends what you did some things you can most not

-Sparkyyy- wrote Well kyle i went to upgrade to 13196 or watever the new dash is and i used the jtag tool and im tryin to reflash my orignial nand but i cant boot into xell

I'm not really the person to ask, check these out tho.

Forums/t=722496/how-to-fix-a-bad-nand.html

Forums/t=856539/active-jtag-techn...-here.html

But, does it boot using eject?

Talk us through the process you followed

well y would u take it out

1.First go to Flash360.xex
2.Press X then Press A wait till its done it shouldn't take long
3.Press back 3 times and then shutdown your Jtag
4.Take USB out of JTAG and plug in to computer go to your Flash360 folder on USB
5.Put the flashdmp.bin on Desktop
6.Open JTAG Tool put in your console type and CPU Key
7.Press Create FB Open up flashdmp.bin
8.Press any button and then when finished press enter
9.When pressed enter it should say save as FreeBOOT.bin rename that to updflash.bin
10.Save the updflash.bin to desktop and then put it in Flash360 Folder on USB
11.Put USB in JTAG and Load up Flash360
12.Load up Flash 360
13.Press A then press A again Then Press start
14.Press back Until Countdown to shut down
15.Once shut down unplug power cable from JTAG leave it out for 30 Secs (MUST PULL OUT OF CONSOLE NOT WALL) and put back and load up your JTAG
i used these steps but i used the voice tut and he just sayed unplug the powerbrick he never said where from

on jtag tool click the spanner, go to drivers / options then 'freeboot eject' click on xellous, create your image and reflash if you can still get into xell that is...

what jtag do you have?