Did you re write the nand?

I assume you had a bad nand flash?

We need more information.

You have a bad flash then. Unless your soldering sucks. Make a new nand image and reflash it.

try making a nand using easyfreeboot and use the option for it to use donor data, this should give you a working nand, with out using your own nand, you will
just need your cpu key

I told you its gonna be somethin other than wiring, especially if you touched the points up before and it didnt work. Next thing to do is re flash the Jtag and test after that.

kane1542 wrote still have e79 after following diagram for soldering zephry jtag here is the link i used to solder [ Register or Signin to view external links. ]

Eugh, been 2 years and people still having the same problems
I assume your E79 was from a bad flash
If your soldering is the problem, check for solder splashes 1st of all
2nd, it is most likely that the nand flasher is not making valid contact with the required nodes. Check your wires are going to the right places and make sure they have a firm connection,
Remember its only for 3 mins you have to hold the wires down with a USB flasher
I dont use any solder anymore with jtags, i leave it open and use blue tack
Make sure your power is on when writing the nand(seems obvious but many forget)
Lastly, my solder points creat a dome shape on the opposite side of the motherboard, so i used the reverse side it you have similar nodes.
Your welcome and PM me if you need any more help

post some pics of your install please.. it will help us check them off the list

give this method a shot aswell

[ Register or Signin to view external links. ]