You are viewing our Forum Archives. To view or take place in current topics click here.
RGH 2.0 Jasper 256
Posted:

RGH 2.0 Jasper 256Posted:

DoctorJ999
  • Wise One
Status: Offline
Joined: Feb 18, 201212Year Member
Posts: 566
Reputation Power: 22
Status: Offline
Joined: Feb 18, 201212Year Member
Posts: 566
Reputation Power: 22
Hello I am Trying to RGH 2.0 My Jasper BB 256, I had it glitching with RGH 1, but it wouldnt boot Xell, i looked at the NAND and saw it was a 6752, so i went an updated it to 14179. Now the CB is 6753, and it doesnt Flash Green anymore. Re- Do My soldering?

EDIT: Flashed Back to stock and i got RROD, error code 0022.
#2. Posted:
5KMods
  • TTG Undisputed
Status: Offline
Joined: Jun 19, 201014Year Member
Posts: 5,070
Reputation Power: 216
Status: Offline
Joined: Jun 19, 201014Year Member
Posts: 5,070
Reputation Power: 216
assuming you removed your cr and flashed back the original nand, i would assume you have damaged Pll_Bypass.

Try reflshing again and also make sure your LDV is correct.
#3. Posted:
DoctorJ999
  • Wise One
Status: Offline
Joined: Feb 18, 201212Year Member
Posts: 566
Reputation Power: 22
Status: Offline
Joined: Feb 18, 201212Year Member
Posts: 566
Reputation Power: 22
I got it, the Post_Out was looking funny to me, so i looked at it with a well lit 5x magnifying glass, it looked like it didnt have enought solder, so i just went directly to the alt point on the top, and its glitching now, but it hasnt booted into Xell, i flashed my Coolrunner with D, and its Set to Phat, and i did connect the Cap points because it is a Jasper. Sp if anyone could help with the glitching that would be great.
#4. Posted:
5KMods
  • TTG Undisputed
Status: Offline
Joined: Jun 19, 201014Year Member
Posts: 5,070
Reputation Power: 216
Status: Offline
Joined: Jun 19, 201014Year Member
Posts: 5,070
Reputation Power: 216
DoctorJ999 wrote I got it, the Post_Out was looking funny to me, so i looked at it with a well lit 5x magnifying glass, it looked like it didnt have enought solder, so i just went directly to the alt point on the top, and its glitching now, but it hasnt booted into Xell, i flashed my Coolrunner with D, and its Set to Phat, and i did connect the Cap points because it is a Jasper. Sp if anyone could help with the glitching that would be great.


RGH2.0 isnt just going to give you instant gltiches it will require different settings to get it to glitch, I was messing with a falcon for about 2 hours and finally got it gltiching within 1-2 mins consistantly had to play with different wire lengths on Cpu_Rst. also used a 10ohm resistor and found it had the best results.

suggest searching around see what others tried and see if it works for you the same.
Jump to:
You are viewing our Forum Archives. To view or take place in current topics click here.