post your secondary error code.

4 lights is 0

ie. 0020

That looks like an older console, so firstly check the secondary error (Press the sync cable and the dvd eject key at the same time once the RRoD comes up, then look at the sequence of lights, (e.g. 0101, one ring of light is 1 two is two, three is three, and four is zero. It will only be four numbers). Either post your secondary error code here or you could PM me the error code and I could do my best to assist you.

After you get that issue straightened out, this would be a good thread to read over a few times:
Forums/t=791843/beginners-guide-t...-2011.html

ok i did what you asked and 4 lights appeared now what?

ImmortalCerebus wrote ok i did what you asked and 4 lights appeared now what?

total of 4 presses this will give you your secondary code.

you will need to note the lights that occur during those 4 presses. and post your code.

ie. 3 lights,(secondary code --> press 1,press 2,press 3, press 4,)3 lights again.

in reference to the video i posted above, his code was 0020

Sorry im still new to this but i pressed it 4 times and the sequence was 4 1 4 2 and i pressed it a 5th time and just went back to the 3 ringed of death

ImmortalCerebus wrote Sorry im still new to this but i pressed it 4 times and the sequence was 4 1 4 2 and i pressed it a 5th time and just went back to the 3 ringed of death

you need a reflow or rebaling service.

if you look up your error code you can search for repairs, its commonly a gpu related error - 0102 is error code