Elmo_Doing_U wrote Hey boys/girls
My jtag has rrod (3 red lights) The error code is 0020
I can not tell what it is but i do not want to try X clamps.
Is there any other way that might help?
If so please post it in the comment section below
Other Info: it only worked for 3-4 days
*The 12volt Fan works Perfectly ( So It might Not Be a Power problem)

Sounds like a bridged solder point.

1)If you worked on the mainboard recently(soldered or so) remove these wires because you might be drawing too much power from the GPU
Also look for missing/bridged components like capacitors/resistors
2) If you jtagged the console remove wires and resistors, the parallel port can stay as long as no PC is connected.
3) X-Clamp replacement
4) Flush with alcohol, let dry, begin Relow with flux like below
5) Reflow GPU (and RAM if this fails) area
6) Reball the GPU and RAM, for bridged solder