TTG_ALF13 wrote Needs to be reflowed end off if you were able to boot into xell then u could update to an older working nand image but you cant boot in to xell so ur **** need to re-soldier everything

yeah, and make sure ur AV cables are plugged in lol

TTG_Co-HoSTv7 wrote Same happened on my jasper

yeah i think what happened is when i put the dvd drive and everything else in, it moved/crushed some points...im going to resolder all the points to ensure they have plenty of room when everything else is installed

yo i fixed it! if anyone else has this issue PM me and ill try to help

lakeand1 wrote hey everyone thanks for all the replies...

what happened is everything worked great when i had it out of the case, i installed a nandx (due to a bad flash earlier) and had it all working. Then I put it all back together and this happened so I'm thinking one or more of my joints got :idea: somewhere along the reassembly

That is what it is, sloppy soldering. Flip the motherboard out and use desoldering braid to remove any blobs of solder present under the nand reading points and make sure nothing is bridged it should work (it may say it overheated for some reason). Check your brige wire (dfb1 i think ) on the Jtag wiring too, if its got a cold solder joint it will brick the console. If your soldering is not the cause, you will need to reflash with your original flashdmp (freeboot image) again.
edit:saw you fixed it ill ask you what it was on aim

Happend to me any help?????
AIM=iiDROPBODYZ