thanks mate but there was a realy good won earlier

idk about having the resistor removed but u can update just fine with it bridged

I'll upload a few mirrors. Give me a few minutes.

drHACKSaPIMP wrote idk about having the resistor removed but u can update just fine with it bridged

y they would waste a e-fuse on this dash update because i dont see y they would even care if some1 downgraded to 9199 its not like theres any exploits on that dash

drHACKSaPIMP wrote idk about having the resistor removed but u can update just fine with it bridged

this is what is confusing me. My resisters are bridged, yet TTG sean said if they ARE bridged then it has to be unbridged.

I'm basing my assumption mine are bridged based on the seller telling me this:

Bridge pin 2&3 of U6T1 or U6T2 (no longer removing R6T3 resistor) to prevent efuse blowing from updates.

So based on the above information are you saying it IS safe to update or do I need to unbridge them? (this is on a xenon btw)

Uploaded a mirror to multiupload.

Should help with the overuse

thanks speed 8) but i know a lot of people who are having trouble

hey guys i have a ? about the dash. Ok so my r6t3 resistor is removed so can i do the update or not? please reply back with a answer

yer hi there i tryed to do this but wid a nother download and it say bad key im getting very pissed ofwid it and i have to fresh k.vs pm if u no wat to do thankzz

ok so on ur tut it says get ur current nand for ur jtag, so do i just use flash360 and get my flashdump thats curently in and use that. or do i need my original nand, btw i do not have my original