Ok guys I am freaking out because I have a E79 on my just JTAGGED Xbox 360. If someone can find me a solution to get this working, I will do anything. So first when I was reading the Nand I found out that I had a bad block, block 36 I think it was. I didnt know that you could remap your bad blocks so I went ahead and flashed XBR, and yes I did the rawkv and rawconfing, but when it was writing to the nand, it said this error, Error: 202 couldnt program block 36, or something like that. Anyways it finished flashing, and when I went to boot up it goes to E79, and I cannot boot into Xell or anything, and it dosent load and of the dash. I looked at my wiring and it looks like on the wires, one or two of the threads from the wire(I used CAT5 wire) were not soldered into it. Could this be the problem? I would really hate having to make new LPT wires to reflash because I was stupid enough to cut the old wires. Most people say that E79 is from bad jtag wiring, and others say it is from a bad flash. If someone can help me I will do anything!!!!!