Move your nand-x?

Make sure everything is secure, you don't want to be working with a damaged nand.

Lol yeah i move it, all the points are secure, i used the wire method(Cut pin headers off), imm gonna try to do it again later to see if anytgihng else happens,

-Marijuana- wrote Lol yeah i move it, all the points are secure, i used the wire method(Cut pin headers off), imm gonna try to do it again later to see if anytgihng else happens,

I used the same method and had the same error at one point but sadly forgot. I think it was something to do with the wire ends touching eachother.

So i should try to to move the wires to make sure there not touching each other?The QSBs just didnt cut it, i tried pin headers but a desoldering iron nor desoldering braid could clean it up.But like the wirews(when i stripped them) had smaller little wires, a couple arent soldered with them, could that also be a problem?

-Marijuana- wrote So i should try to to move the wires to make sure there not touching each other?The QSBs just didnt cut it, i tried pin headers but a desoldering iron nor desoldering braid could clean it up.But like the wirews(when i stripped them) had smaller little wires, a couple arent soldered with them, could that also be a problem?

No cuz I dont think all of mine had each one touching the point. Just make sure a good amount of them are.

Okay, well it just started to work!! so now im happy, i wrote xell to my mobo, gotta get cpu key

make sure the connection is secure going into the nand-x itself, i've had that before, push the connector in as far as it can go - it should be plush with the case

yeah it works now, but look at my post at streamehs sticky thread, that my current problem