nitz0 wrote Well, you don't need to spend on a Reball if all it needs is a re write on the nand.

If you can get it to RROD again and check the secondary error code on it, it'll help pin point better.

1.} I'm new to J-Tag's.
2.} Will I be able to rewrite the Nand?
3.} How do i retrieve the Secondary Code?
4.} How do i make it RRoD?

I'm NOT gonna attept this until I talk to the seller.

lol I'm not saying intentionally get it to RROD, just saying if it does, check the secondary error code..

Just hold the sync button down and hit eject 4 times to get the 4 digit code off the rings..

nitz0 wrote lol I'm not saying intentionally get it to RROD, just saying if it does, check the secondary error code..

Just hold the sync button down and hit eject 4 times to get the 4 digit code off the rings..

Thats the code I said earlier: 0202
(4 Flasing lights then 2 then 4 then 2)

If that's your true sec code, it's unknown...

You need to find out what they did when you sent it back, rework the BGA's or reflash the nand...I'm gonna go with a nand issue but yet I haven't seen it with my eyes but from what you're saying, it's leaning towards reflash.

...And ya thats the code i recieved.
I only use cheap throw away phones so i have no camera. When my girl gets here i will update with a few pics.

By the sounds of it you need it Reflashed

---Update---
It just RRoD'ed again Error Code: 0010
(4 lights flashing then 4 then 1 then 4)

It starts without HHD it shows a lot of coding.

EDIT: No HHD and it works fine.

EDIT: 3 min. on Dash - Error: 0010 again

Coding as in Xell or what?

It's just tough to determine without actually touching it. Could be the Jtag wiring or southbridge related.

Find out what was done when you sent it in and reply back...

I'm still waiting on a reply but when i just went to move it i heard a rattle, so i shook some more and something is definitely loose.

First off, where did you get it?