nobody knows how?

you have to go to a hobby store and buy an air brush and air brush it also while ur there buy some acrilick paint for the air brush the air brush is about 20 for a good one and the piant is about 6 but thats if u want it to be like the ones u buy in the store or offline or u could go to an arts and cfaft store and buy some paint and hand paint it
+ rep but yeah thats pretty much it if u want it to be good and look perfesonly done

and to do the logo u need some painters tape and a extractor knife or a razor but u might want to use a glass table so u just lay the tape on the table and cut a design into it with the knife and sitck it to ur controller where u want it to be

draw it out on a board of ur size then spray it on

Draw it on the controller with a specialist pen then laquer over it so that it doesn't come off over time.

If you've seen Pimp My Ride when they put vinyls on the car, this is pretty much the same thing, just with a controller.


Get the symbol or whatever on a piece of card or whatever it is, put it down onto the controller in the spot you want it, spray over it all, then remove the card or whatever, and voila. Least i think so. I know nothing about this sorta stuff.