what did you use to program your chip?

nand x and jtag tool

delboi1986 wrote nand x and jtag tool

You should go work backwards,if your chip was successfully programmed for the correct console xsvf file then that wouldnt be the issue, try building your ecc file with 360 multi builder v0.03 or best pigs toolbox..

What cb did your console(s) have ? the more detials them more we can help correct your error

-Mafia5K- wrote What cb did your console(s) have ? the more detials them more we can help correct your error

the falcon dashboard was 12625 and i doont know about the japer

delboi1986 wrote

-Mafia5K- wrote What cb did your console(s) have ? the more detials them more we can help correct your error

the falcon dashboard was 12625 and i doont know about the japer

for phat consoles (zephyr,falcon jasper) they require a certain CB to be exploit'd
from tx forums tut:
if you CB version dose not match the ones listed than do not continue

Falcon and Opus 5771

Zephyr 4578 or 4579

Jasper 6750 or 6751

if your CB is correct than continue if not the you console is not exploitable at this stage

open your nanddump in (360 FLASH TOOL) to check CB version

like so:


[ Register or Signin to view external links. ]


read this and follow this tut could'nt hurt :/

[ Register or Signin to view external links. ]


if it turns up being a unexploitable cb version i guess just cut your losses or try restoring it and updating via live then retry, also the jasper may require a extra capasitor to be installed if its a big block revision

my cb is 5771 i have just checked!

delboi1986 wrote my cb is 5771 i have just checked!

there really isnt much left to check if you have taken a look at the tut i linked you too,and it is all correctly done you should check the wiring, or atleast post some pics of your install