You are viewing our Forum Archives. To view or take place in current topics click here.
Command Prompt, NandPro prob.
Posted:
Command Prompt, NandPro prob.Posted:
Status: Offline
Joined: Jul 13, 201014Year Member
Posts: 35
Reputation Power: 1
Status: Offline
Joined: Jul 13, 201014Year Member
Posts: 35
Reputation Power: 1
Hey, I've expirenced some problems with my jtag where it wont show up to my TV,so troy2062 from Youtube suggested I write my orig. nand. And since I took the lpt port off because of missing wires when i bought it, I put on a new one. The diagram I refered to is this one.
Then when I read my nand to check EVERY block came up as an error. So, when i saw this diagram with the switching diode, I added it
Then, after that it came up like this,
Testing lpt device adress:0378
Testing lpt device adress:0278
Testing lpt device adress:03BC
Could not detect a flash controller!
Can not continue
What's going wrong? By the way I have a Xenon if it helps. If someone could help via TeamViewer that would be great, maybe I will pay
8)
Then when I read my nand to check EVERY block came up as an error. So, when i saw this diagram with the switching diode, I added it
Then, after that it came up like this,
Testing lpt device adress:0378
Testing lpt device adress:0278
Testing lpt device adress:03BC
Could not detect a flash controller!
Can not continue
What's going wrong? By the way I have a Xenon if it helps. If someone could help via TeamViewer that would be great, maybe I will pay
8)
You are viewing our Forum Archives. To view or take place in current topics click here.