well dude if u wanna get it repair first u gotta have to read ur nand two times then u gotta write xellous "xell" to get ur cpu key

right now theres no way to launch xell if u did a bad flash so u gotta do what i said in order to both nand and cpu key to fix ur jtag

neto888 wrote well dude if u wanna get it repair first u gotta have to read ur nand two times then u gotta write xellous "xell" to get ur cpu key

right now theres no way to launch xell if u did a bad flash so u gotta do what i said in order to both nand and cpu key to fix ur jtag

How do I go about doing that? This is where I stuck.

do u have nand x ,j-r programmer or lpt wires???

neto888 wrote do u have nand x ,j-r programmer or lpt wires???

I have LPT wires I can use.

ok well like its lpt wires i would suggest u use jtag tool honestly for lpt wires thats the best its outdated but good for the job

do u know how to install them in ur jtag???

As long as your power brick (Psu) is connected to your console, you can read your nand via NAND Flasher (Nand-x,Jr-Programmer,Lpt,etc.) By doing this just make a new img and flash it to the console. Hopefully the console will boot on. If not then, dont really know what to tell ya.. sorry bud

neto888 wrote ok well like its lpt wires i would suggest u use jtag tool honestly for lpt wires thats the best its outdated but good for the job

do u know how to install them in ur jtag???

Yes I do know how to.

ok so basically just re jtag ur console

read nand 2x

write xell

then create image

thats all and it should work

u can use jrunner or jtag tool by coolshrimp