I would recommend sending it to Mafia5K he knows what he is doing and will fix it to working order as well he cleans them before sending them out, But for a small fee of course.
You can send it to any Trusted Seller he is just who I recommend

Unbound_Lobbies wrote i have a falcon jtag it has 3 rrod lights the error code is 0022 is it possible for this to be fix? if so how?

Details
Primary Error code: 3 red lights 3 RLOD
E-Code / Secondary Error code: E10 (No Audio/Video) / 0022
Binary/Hex: 00001010 / 0x0A -> 10
Known fixes:

1)If you soldered anything to the mainboard before it occured, whatever you are powering from this point is drawing too much power so get rid of it.Also get rid of everything that you can see that might bridge anything near the GPU.
2) X-Clamp replacement
3) Reflow GPU and HANA chip
4) If it\'s not the GPU/(H)ANA, it might in rare cases be the CPU and can be fixed by reflowing the CPU.
5) if you flash with xell on JTAG-fixed xbox360 this will appear, flash back to original.
6) also can be caused by a broken trace (see link below).
Related Errors:
Powered by Xbox-experts.com
No Related Errors available!
Description:

This error is caused by a bridged/shorting solder joint under the GPU, (H)ANA-chip or in between.It can also be power related though, for example if you are drawing power from one of the regulators that power the GPU and HANA-chip.Can also be a component that is missing or damaged so look for missing parts near the GPU and the HANA chip. In extremely rare cases it might also be related to the lines that lead from HANA to the CPU.
The chances are however higher that it is the GPU than the HANA chip so you should always first concentrate on the GPU.

Another cause could be due to a broken trace under the board near one of the ram blocks, check the picture in the reference section. Thank you arvydas for reporting this solution!
This error also show up if the CPU ! was taken off the mainboard.

SOURCE --> xbox-experts