You are viewing our Forum Archives. To view or take place in current topics click here.
How To Mod Xbox Controller *EASY*
Posted:

How To Mod Xbox Controller *EASY*Posted:

xPlatinum
  • TTG Undisputed
Status: Offline
Joined: Jun 30, 201014Year Member
Posts: 5,687
Reputation Power: 264
Status: Offline
Joined: Jun 30, 201014Year Member
Posts: 5,687
Reputation Power: 264
Great post. Stickied. NinjaDefuse


THIS IS HOW TO MOD YOU CONTROLLER



This is how to add mods to your xbox controller? Playing Xbox is amazing.There is lots of different things to do.The best thing to have in your hand is a modded controller.So enjoy my tut TTG.





To mod an Xbox 360 controller you will need the following:

Tweezers
Resistor
30 AWG electric wire
Colored surface mount LED's
Hot glue
Solder
Pliers
Portable drill
Utility knife
Wire cutter
Wire stripper
Hot glue gun
Soldering iron
Philips jeweler's screwdriver
Newspaper




STEP ONE.
Put newspaper out on the table. Place controller face down on the newspaper. Take the screws out of the back with your Philips jeweler's screwdriver. Scratch off serial sticker using the screwdriver, then take the screw from beneath the sticker. Take the bottom part of your controller and put it inside.




STEP TWO.
Take controller apart. You will need to remove each part of the controller. The buttons, the rubber contact pads, the thumb stick, the D-Pad and the front as well as back inserts from the controller. Make sure all parts of the controller are placed somewhere like a cup so that none of the small pieces are lost.




STEP THREE
.
Heat up your soldering iron. Touch the tip of the soldering iron with each of the four LEDs that surrounds the circuit board near their contact points. Take out the LEDs with tweezers. Put the four colored LEDs inside the circuit board and replace the four that were removed. Use the solder on each of the contacts and let the solder cool




[size=18].
STEP FOUR
.
Remove the Xbox 360 dome button from your controller. Remove the status ring and the guide button out of your dome button. Place the dome button down on the newspaper with the open end facing up. Insert some hot glue into the dome button. Place three colored LEDs into the hot glue where the contact legs stick up and let the glue set.




STEP FIVE
.Connect the LEDs pin. You will need to start with one LED then bend the negative contact pin toward the positive contact pin of the LED beside it. You will repeat this step until all of the pins except the first one's positive pin and the last one's negative pin has been bent toward one another. Solder all of the pins to hold them in position.




STEP SIX
.
Cut two pieces of six inch long electric wire. You can use the wire cutters to cut the electric wire. You will need to strip the insulation off of both ends of your wire strippers. Solder the end of one wire of the positive contact from the LED that has not been bent. You then need to solder one end of the other wire from the negative contact from the other LED that has not been bent. Put the status ring and the guide button back into your Xbox 360 dome button and put the dome button back in the shell of the controller.





STEP SEVEN
.
Grab and flip the circuit board over. Solder one end of the resistor of the positive contact near the USB cable that is attached to the circuit board. You will then solder the free end of the positive wire of the other contact on the resistor. Solder the free end of your negative contact at which the USB cable attaches to the circuit board. From here you can attach all the the buttons and pieces of the Xbox controller together and enjoy your new modded controller TTG hope you engoyed thanks.[/size]


[ Register or Signin to view external links. ]

THIS COULD BE YOURS AT THE END .TADA.




Last edited by xPlatinum ; edited 8 times in total

The following 57 users thanked xPlatinum for this useful post:

XxModioxModzxX (02-15-2012), vENJOIx (02-10-2012), Azelf (01-21-2012), OklahomaCityThunder (01-09-2012), asianpride94 (12-26-2011), DaRkxEcLiiPs3 (11-14-2011), FF_VIEWER (10-16-2011), TTG-JasonV (10-15-2011), Apu (10-06-2011), ttgpheonix (09-17-2011), Emazed (08-09-2011), DictatorOfYourLife (08-07-2011), marioMod1 (08-02-2011), deathchild (08-02-2011), Morpha (07-28-2011), ReachableFern72 (07-19-2011), Beneath (07-08-2011), chris5001 (07-08-2011), BGUIGS (07-05-2011), madas12340 (07-03-2011), iW3LsHTuRbAnZ (07-02-2011), yankees155 (06-24-2011), TTG_Jabba (06-23-2011), niccee915 (06-21-2011), TTG_VoiDz (06-13-2011), XFEARMODssX (06-01-2011), Flux_Pavilion (05-30-2011), x360BlannKzZ (05-11-2011), Eric1711 (05-04-2011), Abominable_Snowman (04-16-2011), TTG_MODZ_COD (04-16-2011), Neroqz (04-16-2011), ketchup9595 (04-11-2011), TTG_W33DzZ (03-30-2011), Yogi-Bear (03-26-2011), -Recklesss- (03-16-2011), DubN_Leader (03-16-2011), UrBaNViSiOnZ (03-15-2011), JxGreey (03-09-2011), Pozed (01-21-2011), Aznboy38 (01-02-2011), Backpacker (12-21-2010), TTG-TaylorGangOrDie (12-21-2010), Iowa (11-22-2010), ZacDesu (11-16-2010), -HAX0R- (11-16-2010), XDxTxSX (11-07-2010), -Twister- (11-02-2010), Kun (10-30-2010), xDGx_RIVER (10-30-2010), nirragnik (10-30-2010), -TTG-Bebo- (10-28-2010), snype (10-27-2010), iBaTMaN (10-27-2010), EzMoneY (10-27-2010), thundercomet (10-26-2010), SmurFy (10-26-2010)
#2. Posted:
Jake_J
  • Retired Staff
Status: Offline
Joined: Mar 07, 201014Year Member
Posts: 12,067
Reputation Power: 641
Status: Offline
Joined: Mar 07, 201014Year Member
Posts: 12,067
Reputation Power: 641
It's easy for people who know what to do.

Thanked topic. 8)
#3. Posted:
TTG_xZaabri
  • Ladder Climber
Status: Offline
Joined: Oct 23, 201014Year Member
Posts: 345
Reputation Power: 13
Status: Offline
Joined: Oct 23, 201014Year Member
Posts: 345
Reputation Power: 13
Nice TuT i might give it a shot !
#4. Posted:
TheTopModders
  • TTG Addict
Status: Offline
Joined: Oct 05, 201014Year Member
Posts: 2,367
Reputation Power: 155
Status: Offline
Joined: Oct 05, 201014Year Member
Posts: 2,367
Reputation Power: 155
This isn't very easy if u need all these things
#5. Posted:
ALesbianUnicorn
  • TTG Contender
Status: Offline
Joined: Sep 06, 201014Year Member
Posts: 3,480
Reputation Power: 187
Status: Offline
Joined: Sep 06, 201014Year Member
Posts: 3,480
Reputation Power: 187
OMG This Works Thankzzz I Have A 3 Mode One NoW!!!!
#6. Posted:
The_Queen
  • TTG Senior
Status: Offline
Joined: Aug 19, 201014Year Member
Posts: 1,831
Reputation Power: 80
Status: Offline
Joined: Aug 19, 201014Year Member
Posts: 1,831
Reputation Power: 80
Nice tut. Hope it works for future.
#7. Posted:
xPlatinum
  • TTG Undisputed
Status: Offline
Joined: Jun 30, 201014Year Member
Posts: 5,687
Reputation Power: 264
Status: Offline
Joined: Jun 30, 201014Year Member
Posts: 5,687
Reputation Power: 264
Nature wrote It's easy for people who know what to do.

Thanked topic. 8)
thanks nature nice man
#8. Posted:
xPlatinum
  • TTG Undisputed
Status: Offline
Joined: Jun 30, 201014Year Member
Posts: 5,687
Reputation Power: 264
Status: Offline
Joined: Jun 30, 201014Year Member
Posts: 5,687
Reputation Power: 264
TTG_FatModderz wrote OMG This Works Thankzzz I Have A 3 Mode One NoW!!!!
enjoy your sexy controller lol
#9. Posted:
GraphicZ
  • TTG Senior
Status: Offline
Joined: Sep 15, 201014Year Member
Posts: 1,387
Reputation Power: 55
Status: Offline
Joined: Sep 15, 201014Year Member
Posts: 1,387
Reputation Power: 55
Wow that was very detalied llz
#10. Posted:
xPlatinum
  • TTG Undisputed
Status: Offline
Joined: Jun 30, 201014Year Member
Posts: 5,687
Reputation Power: 264
Status: Offline
Joined: Jun 30, 201014Year Member
Posts: 5,687
Reputation Power: 264
yeah i knoow tryed to make it as good as possable as im trying to get the post hi in the forums mate:D
Jump to:
You are viewing our Forum Archives. To view or take place in current topics click here.