HITMAN5665 wrote I just got done writing xell with Jtag Tool through a LTP cable. But whenever I press the eject button to start xell, i get 2 red lights.
Btw i fixed RROD on the consle.

What's the secondary error code?

2 Lights means it is overheating

If you installed xell, turn it on with the power button

Ryan6578 wrote

HITMAN5665 wrote I just got done writing xell with Jtag Tool through a LTP cable. But whenever I press the eject button to start xell, i get 2 red lights.
Btw i fixed RROD on the consle.

What's the secondary error code?

So when i press the eject button it flahes 3 lights super quick then goes into 2 lights

xColorado880 wrote 2 Lights means it is overheating

If you installed xell, turn it on with the power button

the thing is not warmer than room temp

xColorado880 wrote 2 Lights means it is overheating

If you installed xell, turn it on with the power button

Three red lights with the secondary error code 0102 is overheating.

just over heating let cool down for a few hours and then after that get a fan and put it by it thats what i do and it works

Tell me the secondary error code. How to get secondary error code:


* Turn the xbox 360 on, and wait till the 2 red lights are flashing.
* Press and hold the sync up button (the small white one), while holding that button press the eject button.
* The LEDs will now blink the first number in the code (as described below).
* Release the eject button and press it again.
* The LEDs will now blink the second number of the code.
* Release the eject button and press it again.
* The LEDs will now blink the third number of the code.
* Release the eject button and press it again.
* The LEDs will now blink the forth number of the code.
* Release the eject button and press it again.
* The LEDs will go back to the 2 red flashing lights.

Key:

* All four lights flashing - 0
* One light flashing - 1
* Two Lights flashing - 2
* Three lights flashing - 3

Ryan6578 wrote Tell me the secondary error code. How to get secondary error code:


* Turn the xbox 360 on, and wait till the 2 red lights are flashing.
* Press and hold the sync up button (the small white one), while holding that button press the eject button.
* The LEDs will now blink the first number in the code (as described below).
* Release the eject button and press it again.
* The LEDs will now blink the second number of the code.
* Release the eject button and press it again.
* The LEDs will now blink the third number of the code.
* Release the eject button and press it again.
* The LEDs will now blink the forth number of the code.
* Release the eject button and press it again.
* The LEDs will go back to the 2 red flashing lights.

Key:

* All four lights flashing - 0
* One light flashing - 1
* Two Lights flashing - 2
* Three lights flashing - 3

I got 0012? 20charactors

The issue is you GPU not making good contact...Remove the heatsink and apply some more thermal paste and re adjust your bolts and test again..

Once you get this error out of the way, you can see if your nand write was successful.

If you get the error again, you can remove the top 4 metal washers from the top side of the motherboard if you're using the standard nylon/metal washers.

-360RepairKings