You are viewing our Forum Archives. To view or take place in current topics click here.
Bent CPU Pins causing high temperatures ?
Posted:
Bent CPU Pins causing high temperatures ?Posted:
Status: Offline
Joined: May 27, 201311Year Member
Posts: 515
Reputation Power: 22
So yesterday while installing my CPU into a new motherboard i dropped my AMD Athlon X4 860K on the floor and i manged to straighten the Pins and install the CPU but im getting 80 Degrees Celsius as a temperature at idle ??
not sure what to do any suggestions ?
not sure what to do any suggestions ?
#2. Posted:
Status: Offline
Joined: Apr 24, 201212Year Member
Posts: 3,645
Reputation Power: 316
Status: Offline
Joined: Apr 24, 201212Year Member
Posts: 3,645
Reputation Power: 316
Is the fan spinning? if not that's your problem.
But otherwise it's probably now faulty, I've dropped Intel chips for laptops and bent the pins back but they've been fine. Are you sure you didn't snap a pin off?
Also your FPS problem is probably being caused by this too.
But otherwise it's probably now faulty, I've dropped Intel chips for laptops and bent the pins back but they've been fine. Are you sure you didn't snap a pin off?
Also your FPS problem is probably being caused by this too.
- 0useful
- 0not useful
#3. Posted:
Status: Offline
Joined: May 27, 201311Year Member
Posts: 515
Reputation Power: 22
FPS was an issue before i dropped it but all pins are there and fan is spinning so not sure i installed new thermal paste and it just evapourated with the heat
- 0useful
- 0not useful
#4. Posted:
Status: Offline
Joined: Apr 14, 201113Year Member
Posts: 1,735
Reputation Power: 69
Shouldnt, i brought an FX-6300 of a friend and a couple of the pins were bent and it wouldn't go in the socket.
Faffed around with the CPU for a while with some tweasers and straightened the pins out and its fine, I've had absolutely no issues.
I Would assume its possible, but i doubt it, i wasn't too careful bending mine back and its still fine.
Have you looked into RMA'ing the CPU?
Faffed around with the CPU for a while with some tweasers and straightened the pins out and its fine, I've had absolutely no issues.
I Would assume its possible, but i doubt it, i wasn't too careful bending mine back and its still fine.
Have you looked into RMA'ing the CPU?
- 0useful
- 0not useful
#5. Posted:
Status: Offline
Joined: Aug 20, 201410Year Member
Posts: 6,813
Reputation Power: 413
Status: Offline
Joined: Aug 20, 201410Year Member
Posts: 6,813
Reputation Power: 413
You say the thermal paste 'evaporated'? I would check again and reapply it.
- 0useful
- 0not useful
You are viewing our Forum Archives. To view or take place in current topics click here.