In this tutorial I will be giving simple instructions on how to

RGH2 A Corona 4GB

---

Parts required / Used in this tutorial

---

Step 1- Identifying if your console needs a post fix adapter

To do so you need to remove the heatsink from your Corona mother board and look for these traces

---

Step 2 - Soldering on the pin headers Make sure to install wire as shown!

---

Step 3 - Plug in your Maximus SD Tool



Next

Plug power into console (DO NOT POWER ON CONSOLE)

Plug SD Card Reader into PC

---

Step 4 - Finding out your Drive Letter
You will receive a notification asking you to FORMAT A Specific Drive (Remember that Drive Letter and hit cancel) Do not format the drive!

---

Step 5 - JRunner 17511

Open up Jrunner and Press Read Nand



Step 6 - Creating and Writing the ECC

Press Create ECC*



Next Press Write ECC



Now with Xell flashed to console we need to install Ace Chip & disconnect wire from pin header

Step 7 - Installing Ace Chip

Things to note, the Ace v3 chip comes pre installed with Corona Timing Files (no flashing to the Ace is required)

Solder the Points as shown below

---

Step 8 - Booting into Xell & Acquiring CPU key

Boot up the console to Xell

---

Step 8.5 - Jrunner with CPU Key

Now enter your CPU Key into Jrunner



Then hit Create XeBuild Image , Once its complete we will now reconnect the wire to the pin header and oscillator , reconnect our Maximus SD Card Reader and flash the new XeBuild image , thus completing the Corona RGH2

---

Step 9 - Flash Final Image

Set up Pin Header again



Plug Console Power in - Do not boot console

In Jrunner Press Write Nand



Remove wire from pin header and recase it back up and your good to go.

There are a lot of tutorials out there all pretty chopped up in their own way if anyone sees an area that needs improvement let me know