You are viewing our Forum Archives. To view or take place in current topics click here.
#61. Posted:
TPW
  • TTG Fanatic
Status: Offline
Joined: Jan 01, 201113Year Member
Posts: 4,832
Reputation Power: 215
Status: Offline
Joined: Jan 01, 201113Year Member
Posts: 4,832
Reputation Power: 215
Click the eject button, Smack the top of the xbox, and then close the dvd tray with the button but dont let it close it will try to close then stop, then do it agen, hold it for 3 seconds and then it will go on really fast, i think that resets the laser, Worked with me yesterday ;)

















Xenons bbn)
#62. Posted:
TTGGUNER
  • Powerhouse
Status: Offline
Joined: Dec 29, 201013Year Member
Posts: 402
Reputation Power: 18
Status: Offline
Joined: Dec 29, 201013Year Member
Posts: 402
Reputation Power: 18
soz iv tryed that it not work
#63. Posted:
-AndrewMoDz-
  • Rising Star
Status: Offline
Joined: Dec 18, 201013Year Member
Posts: 774
Reputation Power: 37
Status: Offline
Joined: Dec 18, 201013Year Member
Posts: 774
Reputation Power: 37
You can try when opening it,close it then TAP the top of the disk tray lightly.

That usally works for me..
Hope i Helped.


-AndrewModz
#64. Posted:
Tera
  • TTG Senior
Status: Offline
Joined: Aug 09, 200915Year Member
Posts: 1,005
Reputation Power: 67
Status: Offline
Joined: Aug 09, 200915Year Member
Posts: 1,005
Reputation Power: 67
U HAVE TO OPEN UP XBOX
It an issue within

-take off case n open up

-unplug ur drive

-pull drive out n remove its caseing covering ur drive

-you then pull tray out of drive slowly

-you will hear a loud clicking noise this is natural

-when trays fully out remove ruberban under tray gentaly with toothpic or other small utensile
clean it an then reapply it back to where it was

-make sure everythings clean an replug in an test it




To fix with out opening xbox with screwdriver

One of the common faults on the Microsoft XBOX 360 is the DVD Drive tray failing to open all the time, this usually happens with the Samsung TS-H943 drive (you can identify the Samsung drive by looking at the tray photo below). It could be that it opens when the console is horizontal but not vertical. Or you may have to poke the tray, or tap the top or rear of the console to get it open. When the eject button is pressed the tray moves slightly, the power LED blinks and the dashboard thinks the drive is opening, then it thinks its closing etc. You might also find that it opens fine if you have a disc in the drive already.

There is a small rubber belt that opens the tray, this may have stretched slightly due to heat or it may be slightly slippery. It is possible to remove this small belt WITHOUT opening up your console and voiding your warranty. You have to be very careful, ideally you need a pair of long tweezers.

Power your console up and do what it takes to get the drive to eject! Then pull the power lead out of the back of the console so it's switched off with the tray open.

very important - tie something around the DVD tray so that it can't close, a piece of string, a rubber band anything that will stop it closing up - once you have removed the belt the tray will open and close freely and if it closes up completely then you may not be able to open it up without taking the whole console and drive apart.

Now, very, very, very carefully use your tweezers to remove the belt shown in the photo. Try and grab a small part of it and pull it off of the small wheel first, keep a good tight grip of it so that you don't drop it inside of the drive! Finally pull it off of the bigger wheel and out of your console (with the belt removed the tray is loose and closes very easily).

You've got a couple of options, some people place the drive belt in just boiled water for a couple of minutes, clean it with alcohol or glass cleaner. Alternatively you can purchase a new belt and fit that. I used one with a 19mm diameter (Maplins part number FD36P). Old belt on the left, new smaller belt on the right (it's quite a bit smaller, but it stretches and fits perfectly).

Again, got to be really careful when fitting it, try not to handle it too much as grease from your fingers may cause it to slip once fitted. Fit the belt over the bigger wheel first (it looks like it only just fits over the wheel), and then with a fine screwdriver hook the belt and pull it over the smaller wheel. That's it - power it all back on and test it out!
[ Register or Signin to view external links. ]

Hope I HELPED ANYONE FEEL FREE TO PLUS REP IF I HELPED YOU


Last edited by Tera ; edited 5 times in total
#65. Posted:
TTGGUNER
  • Powerhouse
Status: Offline
Joined: Dec 29, 201013Year Member
Posts: 402
Reputation Power: 18
Status: Offline
Joined: Dec 29, 201013Year Member
Posts: 402
Reputation Power: 18
iv lost my t 10 screwdriver
#66. Posted:
Murkedd
  • TTG Champion
Status: Offline
Joined: Jul 16, 201014Year Member
Posts: 8,027
Reputation Power: 368
Status: Offline
Joined: Jul 16, 201014Year Member
Posts: 8,027
Reputation Power: 368
Hammer + Xbox = Go buy a new one.

Your xbox will keep giving you the problem. Even if you temporarily fix it with a hobo fix.

Or you could make it look like someone broke into your house and stole it lol

Free xbox lol

I don't suggest the last idea.
#67. Posted:
TTGGUNER
  • Powerhouse
Status: Offline
Joined: Dec 29, 201013Year Member
Posts: 402
Reputation Power: 18
Status: Offline
Joined: Dec 29, 201013Year Member
Posts: 402
Reputation Power: 18
ok guy last nihte i turned my xbox yeah i went on it agen in the morning it worked i went and played cod 4 then i put black ops in open tray put cod 4 in open tray ffs
#68. Posted:
iTz-Zachu24
  • Wise One
Status: Offline
Joined: Oct 22, 201013Year Member
Posts: 552
Reputation Power: 20
Status: Offline
Joined: Oct 22, 201013Year Member
Posts: 552
Reputation Power: 20
i fixed mine by opening my Xbox and tapping on my cd drive... fixes it quickly... but if u cant open ur xbox idk what 2 tell you
#69. Posted:
TTGGUNER
  • Powerhouse
Status: Offline
Joined: Dec 29, 201013Year Member
Posts: 402
Reputation Power: 18
Status: Offline
Joined: Dec 29, 201013Year Member
Posts: 402
Reputation Power: 18
i can open it but what do i do lok at it till it works
#70. Posted:
TTGGUNER
  • Powerhouse
Status: Offline
Joined: Dec 29, 201013Year Member
Posts: 402
Reputation Power: 18
Status: Offline
Joined: Dec 29, 201013Year Member
Posts: 402
Reputation Power: 18
iv got my t10 screwdriver bk so if i open it what am do i have to do it fix it
Jump to:
You are viewing our Forum Archives. To view or take place in current topics click here.