This is only Rapid fire mod so if you have any other types of modded controllers like quickscope mod jitter mod or 8 mode rapid fire comment on my wall/page on how to.


Materials needed
__________________________
*A TT8 Torx Driver
*A Small Push Button Switch
*Some Thin Wire, Any will do (I used IDE Cable)
*An Xbox 360 Controller (Wired or Wireless, it works the same)
*Soldering Iron
*A Drill and Drill bit (To match the diameter of the thread on your switch)
*Some form of surface to work on.

1.Taking the battery out reveals another screw, its underneath the barcode sticker.
There are 7 screws to remove, so grab that Torx driver and twist! (Anti -Clock-wise)
With the buttons facing DOWN , separate the two halves carefully, paying attention to the motors.

2. Find the best place to put your switch, choose very carefully, as once you've drilled you cant remove the hole from your 30 Controller!Once you have found a place, put the two halves back together and see if there is enough room for your switch to go in.If there is, well done. Remove the circuit board so that it doesn't get damaged, then you can drill the hole and improve 32 worth of electronics.

3.Put the switch in your new hole. Make sure that you orient the pins so that they are not getting bent or squashed when the controller is back together. I had to remove some of the motor holder to fit my switch in.

4. Heat up the soldering iron, not too hot or else it might break some components.

5. Are the switch pins going to make contact with anything on the other half of the controller when reassembled? Are all of the wires free from places of movement or screw holes? Are the solder joints correct and not dry? Are all of the annoying black pieces of the controller back on their positioning pins(they are annoying as they have a habit of coming off the pins half way through putting it back together). Has your soldering iron made suitably sized black marks on your work space? Four out of five is good enough to continue. For a quick test, replace the battery and depress your switch all the way. If the player one LED lights up very dimly, then the mod worked!Now try putting it back together without breaking anything.

6. If you are having trouble putting it all back together, try wigging it while applying gentle force, and make sure all wires and button rubbers are not obstructing anything.

P.S. Any questions find my Wall/Page and ask

~ oRPGONASTICKo










:2thumbsup: :2thumbsup: