Supplies/Tools needed:
1. Phillips head screwdriver for wired controller.
- Security Torc T9 driver for wireless controller.
2. 0603 leds I recommend buying them from [ Register or Signin to view external links. ] "
They range from 24 cents to mid 30 cent range. Far cheaper then mod sites.
3. Soldering Iron + Solder.
4. A pair of tweezers. Optional, for getting the lcd into position for tacking.



Here is a picture of a single lcd. Notice these are
extremely small, and this mod is not for the faint of
heart, but hey your reading my tutorial no worries.



Now you will need to remove all the screws. There will be a hidden screw underneath the serial number. Its in the middle, feel around and you will locate it.

Once you have done this peel that controller apart and set the pcb down. Now look at the middle of the pcb, (green card, with lots of stuff on it) you will notice the small lights, there are four of them.

I will describe the process of floating these leds off and put up the link to a site that shows how its done in a nice neat little video. I tried to create my own, but was to difficult to do by myself.
First heat up the soldering iron, grab your solder, and place a little down on both sides of the led, now heat it up as fast as you can and push the led to the side with the iron when the solder is heated and it will peel off. This takes a little bit of effort, but after you complete one the rest will fall in short order.