FLASHING WITH THE X360 AND CK3 LITE

TOOLS NEEDED: X360 USB Pro + ck3 lite (im using a benq drive + if this tutorial is liked i will make one for the lite-on phat dvd drive)

*NOTE* INSTALL DRIVERS FOR X360 USB PRO! first! *NOTE*
x360 setup

Well to begin lets start with the hardware setup

[ Register or Signin to view external links. ]


Now lets move to the computer

assuming that you have jungle flasher ready, all firmware in place, and jungle flasher is running. lets start

1.select "MTK FLASH 32"
2.make sure the drive info shows up "benq drive"
3.make sure the x360 usb pro is selected
4.make sure the I/O is 0x000
[ Register or Signin to view external links. ]

1.click on "benq unlock"
2.the drive will be shown in vendor mode
[ Register or Signin to view external links. ]

1. click on "read" (this gets the drive current firmware)
2. save the "OFW" (original firmware) to a folder that will make it easy for you use it
[ Register or Signin to view external links. ]
[ Register or Signin to view external links. ]

1. here its asking you if you wanna auto-load LT+, select yes (like the picture below) + my drive key is crossed out
[ Register or Signin to view external links. ]

1.this is the current firmware your drive holds (stock)
2.drive key - DO NOT TAMPER WITH THIS! KEEP IT SAFE!
3.this is the firmware were going to load onto your drive (in this case its LT+2.0)
[ Register or Signin to view external links. ]

1.select "MTK flash32"
2.select "write" to begin the firmware write
[ Register or Signin to view external links. ]

the Write went good!
[ Register or Signin to view external links. ]

1.click on "outro/ATA RESET" (this takes the drive out of vendor mode)
[ Register or Signin to view external links. ]


Hope this Helped!put my time into this and made this all my self!, if this tutorial is liked i will make a tutorial For the "lite on drive"!