Wash All pieces that will be painted in warm water
Makesure you have 800, 1500 & 2000 grade sandpaper (to privide the mirror finish)
Makesure any bit of sanding you do is wetsanding, Fill a bucket up with warm water and put a little bit of dish washing detergent in (acts as a lubricant and helps the sandpaper along).
Use a sanding block if you have one. After each sand on each piece of the case wash it thoroughly then let it to dry naturally. Don't towel dry it.

Ok now sand the case with 800grade sandpaper (wetsanding) once the whole case is done, check it out. Should be SUPER smoothe.

Apply a first ghost coat of sandable primer, let dry for 10minutes then do a normal coat of sandable primer, attack it with 800wet sanding once again. (Doesnt matter if original bits of the case end up showing through).

Once the primer is in A1 condition, Give it a guide coat of the first layer of paint you will be using, allow 30mins to dry. Then give it a Normal coat. Let that dry. Once that has dried give it a second coat, then once that second coat of normal layer paint has dried Whip out yout 1500grade sandpaper, (by this stage the case should be super smoothe, your just working on your painting quality) wetsand ththe whole case, in a ONE WAY DIRECTION. DONT!!! Go in circles or left & right then forwards & back because you will create cross texture in the paint and really start making a mess of things.

ONCE that is done with the 1500grade sandpaper. Wash it, Let to dry naturally.

OK! Now give it another Coat of paint....

Let that harden for a few hours...

Now CLEARCOATING!!

Apply a first guide layer of clear. Not too light & Not too dark. Then let it harden about 30/40mins for this.
Ok now apply a decent layer of clear, not too thick or anything and it must be even, spray in sweeping motions and dont start/stop spraying while on the object itself otherwise you will cause pilling of the paint.

Now once that has Dried about 1/2hours Brake out the 2000grade wetsand paper. Do the same sanding method but do it VERY EVENLY and not as HARD on the pieces you are sanding. Once done. Wash & let it dry naturally.

Apply its last layer of clear evenly. LET it harden overnight before you touch it.

!!GETTING THAT MIRROR FINISH THAT YOU ALWAYS WANTED!!


After letting it cure for 3/4days without handling it, Get some decent Cutter & Liquid Wax Polish. Apply a VERY VERY small ammount of cutter on a hand pad and get to work on the item dont do it too hard or too long otherwise you'll eat down into the color and stuff up. Once you have done this use a cheasecloth to buff it up. Ok about 15minutes after you have buffed the cutter off the item, Time to brake out the LIQUID WAX POLISH!!!

Apply a generous ammount to the item you are waxing and have a fresh handhelf buffing pad, get to work, Once it is all done, get another piece of cheesecloth and put some elbow grease into it and really buff it up, Once the Liquid Wax is applied leave it to sit for 15mins before handling..

Congrats, depending on the quality paint you used.

!!MIRROR FINISH!!


Hope you all have fun... and produce some awesome Paintjobs.